OBDII,Toyota,Code,Reader,eBay, car OBDII Toyota Code Reader on eBay
In the shape of the design, the Core wing broke through the traditional appearance of the other models, the Core-wing sense of movement and high-level sense of the high degree of balance, which must be improved, both in the interior styling General Lee: For such a TSP platform, indeed, is the test of the ability to integrate the same time, just She always has been mentioned in the business platform is a completely independent intellectual property platform and our platform is t
I ordered a Mini-VCI Techstream cable on eBay and can confirm that it works with the Techstream software on a 2001 Prius.However, this should be compatible with all Prius' with the J2534 connector (Standard OBDII 16-pin connector).Using the cable I was able to connect to all 7 ECUs and read 3 digit information codes.Using my generic OBDII cable I could only connect to 3 ECUs (2 engine, 1 hybrid) and could not read info codes.You should be able to reprogram the immobilizer with this cable, but you won't be able to without knowing/calculating security codes. (You will probably find it too expensive to buy a computer program to do the same, or impossible to find online.) So don't count on this capability.did u get the answer to the reverse beep...if not this may helpcan't give proper credit as I don't remember where I found it.Prius Beeper disableTo eliminate the beeps from seatbelts and reverse, follow these steps:1. Power on the car to IG-ON or READY. IG-ON will do for this purpose.2. Using the Trip/ODO button, set the Trip/ODO display to ODO (not Trip A or Trip B)3. Power off the car.4. Now power the car to READY (brake on). This is required so that step 6 works correctly.5. Within 6 seconds of powering on, press and hold the Trip/ODO button for 10 seconds or more (there is no indication... just count)6. WHILE STILL HOLDING ODO *after* the 10 seconds, shift the "gear" selector to R, then press the P button. Now release the Trip/ODO button.7. If the last step was successful, "b on" or "b off" should be displayed in the location where the Trip Odometer or Odometer is normally displayed (front dash area). "b on" is beep on (default), and "b off" is beep off.8. Press Trip/ODO to toggle the mode.9. Now power the car off to exit the toggle mode.10. Power the car on to READY and confirm the reverse beep status by shifting to R. The beep should not be audible if "b off" was selected, and should be audible if "b on" was selected..Note: The Repair manual page states that if the the 12v battery is disconnected, the beep will reset to the default of on, and this procedure will need to be performed again - I have confirmed this to be true!. The repair manual also is not clear that Trip/ODO should remain depressed while shifting.Additional Note: The driver and passenger seatbelt reminder chime can be disabled or enabled (respectively, defaults are driver on and passenger off) using similar steps. Instead of shifting from P to R to P in step 6, simply buckle then unbuckle the appropriate seatbelt while continuing to depress the Trip/ODO button. Might want a helper for this one! Article Tags: Trip/odo Button
OBDII,Toyota,Code,Reader,eBay,