DIY,Oil,Change,Guide,you,enjoy car DIY Oil Change Guide
In the shape of the design, the Core wing broke through the traditional appearance of the other models, the Core-wing sense of movement and high-level sense of the high degree of balance, which must be improved, both in the interior styling General Lee: For such a TSP platform, indeed, is the test of the ability to integrate the same time, just She always has been mentioned in the business platform is a completely independent intellectual property platform and our platform is t
If you enjoy your current vehicle and are intent on keeping it around for a while, the first maintenance task youre likely going to need to look into is the oil change. And if youre a hands-on kind of person who doesnt mind a little dirt and grime from time to time, you may decide to take care of this little project on your own. If youre unfamiliar with the process, dont worry once youre through with this quick little step by step youll be in and out in no time.Materials:Adjustable oil filterAdjustable wrenchOil drain pan8 quarts of new oil1 new filterRagsStep 1 Before starting the oil change procedure proper, youll want to turn on the vehicle and let the engine run for 5-10 minutes in order to ensure that the oil is warm. This will warm up the rest of the car so be sure to be careful when maneuvering underneath to locate the drain plug.Step 2 Once youve found the plug, grab your pan and position it directly underneath it. Remove the dipstick, allowing air to enter the pan. Step 3 Grab your wrench and use it to loosen the drain plug. Youll want to complete the removal by hand once youve got it going. Remove it and allow everything to drain out completely into the pain. Drainage can take a few minutes. Step 4 While the oil drains, grab your filter wrench and remove the oil filter. Take care to adjust the chain on the wrench so that it fits your filter. Turn counter-clockwise until it is loose and finish the removal by hand. The filter will still be filled with oil, so position it upside down in the oil pan and give it time to drain.Step 5 After the draining has completed, clean the area and replace the plug. Its an easy detail to forget, but vital to the success of your task. If you happen to forget, dont worry, as youll remember a few steps from now once a pool of black fluid begins forming around your shoes.Step 6 Take your finger and dip it into the new oil, spreading a thin film over the rubber gasket located just around the opening of the new filter. This process lubricates the filter and ensures it sits better.Step 7 Replace the filter onto the engine mount in the same spot which you removed the old one from. Avoid using the filter wrench to tighten the filter as this will almost always end it a split gasket. Tighten by hand to be safe.Step 8 Once all of your pieces are back in their place, you can start adding the new oil through the oil port in the valve cover. Add just a little bit less than the owners manual specifies and then check your level with the dipstick. It can sometimes take a few minutes for everything to settle. Step 9 Check out the underside for leaks and start your vehicle, leaving it idle for at least 10 minutes. Check again for leaks. Thats it! You've just completed an oil change.
DIY,Oil,Change,Guide,you,enjoy