How,Avoid,Dynamic,Rollover,Hel travel,insurance How to Avoid Dynamic Rollover in Helicopters
Like any American, traveling occasionally is just what I love doing and I bet you share the same stuff with me. But traveling does not mean that you would be safe. Escaping from our job and other stressful activities is just something that w Torres del Paine is among the biggest of Chiles national parks, occupying almost 600,000 acres (242,000 ha) of land in the south on the border with Argentina. It is also among the most important, receiving a significant proportion of domes
What is dynamic rollover? Dynamic rollover sounds like a phrase that could be used by the lottery companies. Each helicopter pilot is aware that dynamic rollover can be a problem when taking-off or landing a helicopter. Dynamic rollover is caused when a wheel or a skid on the helicopter becomes attached to the ground and acts as a pivot point that the helicopter can roll around. It is much more likely to happen on take-off, and if it is not handled correctly, the helicopter will roll over onto its side and take substantial damage. This does occasionally occur to experienced pilots but is much more likely to happen with low time pilots. Have you ever attempted to pull the handle of a door and the door refuses to move? Then, when you push the handle the door opens and takes you by surprise. You were not expecting it to happen. The same thing may happen during a take-off. You raise the collective smoothly and one of the skids lifts of the ground. You anticipate the other skid to follow but unfortunately it is caught on something and refuses to move. Your natural reaction is to raise the collective further to make the helicopter break free of the ground but all you achieve is a fast roll of the helicopter towards the stuck skid. The inertia of this roll may be sufficient to keep the helicopter rolling over even though you now lower the collective. The inevitable happens and the helicopter rolls over unto its side and suffers severe damage. The natural reaction to raise the collective to correct the problem is the wrong reaction and you must discipline yourself to do the correct action which is lowering the collective smoothly until both skids are on the ground. Results The results of a dynamic rollover are usually very severe. The helicopter is usually destroyed. The damage from a helicopter rolling over at the end of an auto-rotation is much less than the damage caused by dynamic rollover. This is because during an auto-rotation the blades are unpowered and if it rolls over, it will quickly come to rest. During a take-off however, you will be using a lot of power and if the helicopter subsequently rolls over, it will not come to rest so quickly and much more damage will occur. Take-off It can be seen that take-offs may cause a problem. Icy ground and frozen skids can be a real problem. Muddy or sticky ground, rocks, joints in concrete can all cause skids to catch and lead to dynamic rollover. Care must be taken during each take-off but particularly the first take-off. Make sure you are looking well ahead. Raise the collective smoothly until you feel the helicopter get light on the skids. From this point onwards, you must move the collective very slowly. The closer you get to taking off, the slower the collective should be moving. Try a small "wiggle" by moving the pedals slightly. This will give you an indication if both skids are free. If you are on a level surface, one skid will probably start to rise before the other. It is essential not to rush the collective at this stage. If you feel the helicopter is rolling over too far, smoothly lower the collective and ensure that both skids are on the ground before recommencing the take-off. When both skids (wheels) are clear of the ground, get the helicopter to a safe height to make sure that the skids do not inadvertently catch on something. When the helicopter is on the ground with the blades turning, never take your hand off the collective unless the collective is fully down and locked. There have been many instances of passengers moving the collective or collectives vibrating up until the helicopter rolls over. Making sure that the aircraft is within its balance limits will also ensure that you do not run out of cyclic travel during normal take-offs and landings, thereby reducing the risk of dynamic rollover. Further information on this subject may be found at Dynamic Rollover in my helicopter training blog.
How,Avoid,Dynamic,Rollover,Hel