Unclogging,Showerhead,your,sho homerepair how to Unclogging a Showerhead
This year when you go up into the attic to get the Christmas decorations take a look around the attic to see if there is any frost on the roof ceiling or rafters. If there is then you have a moisture problem that should be taken care of. Moi Elegance and style are mostly the factors why timber flooring is well-liked to home builders. Aside from that, timber flooring is one of the most gorgeous and long-lasting flooring options that any homeowner could make. It's going to add val
If your shower water pressure is not what it used to be it could be one of several problems, however it is most likely a clog in the showerhead itself.In the showerhead unit, there is a small filter screen. This filter screen is meant to prevent small particles of sediment from clogging the tiny shower holes in the showerhead assembly. However, if you have noticed the showerhead water pressure has slowly diminished overtime; chances are the filter is clogged.To unclog the showerhead you first need to unscrew the shower head from the shower pipe. Use a crescent wrench to unscrew the clogged showerhead.Once you have unscrewed the clogged showerhead, you will find a small filter that sits just inside the showerhead. Using either your fingers or a small set of pliers (e.g. Needle Nose pliers) remove the filter screen from the showerhead.If you see sediment on the filter screen rinse it off thoroughly. Then reinsert the filter screen back into the showerhead.Next, if there is old plumbing tape (Teflon tape) on the shower pipe, remove it.Wrap new plumbing tape around the pipe and then screw on the showerhead. Note: When applying the Teflon tape, wrap it around the pipe in the same direction that the showerhead will be tightened.Tighten the shower head with a crest wrench just so it is snug.Turn the shower on and observe if there is a significant improvement in the showerhead water pressure.If you don't see a marked improvement in your showerhead water pressure, you could still have one of several problems. It may be that the showerhead holes are clogged. If this is the case, then you will need to remove the showerhead again and soak it in a vinegar water mixture to dissolve away any build up in the holes.If you notice that your water pressure is low in your entire home then you may have a problem with you well pump or water holding tank. If this is the case, you will need to call a plumber. Article Tags: Showerhead Water Pressure, Water Pressure, Filter Screen, Showerhead Water
Unclogging,Showerhead,your,sho