Water,Heater,Installation,Step homerepair how to Water Heater Installation: A Step By Step Approach
This year when you go up into the attic to get the Christmas decorations take a look around the attic to see if there is any frost on the roof ceiling or rafters. If there is then you have a moisture problem that should be taken care of. Moi Elegance and style are mostly the factors why timber flooring is well-liked to home builders. Aside from that, timber flooring is one of the most gorgeous and long-lasting flooring options that any homeowner could make. It's going to add val
Perhaps one of the most common household plumbing projects is that of replacing the hot water heater. However, there are many dangers which can result from an installation if not properly done. In this article, we will outline a step by step plan to help make your heater installation a success.A list of materials needed: 1. Dolly2. Hose3. Pipe Wrench4. Slip joint pliers5. Pliers6. Torpedo level7. Teflon tape8. Masking tape9. Joint CompoundStep 1 - Selecting the UnitIf you happen to be installing a new heater, you have a number of options available in terms of size, type, and power source. Do a little research to gain some education and make an informed decision. Also be sure to check with your local building codes to make sure you choice is approved. Step 2 - PreparationMake sure all switches & valves are turned to the off position. For safetys sake, place a bit of tape over the electrical switches to prevent someone from accidentally causing an incident.Step 3 - Place the New TankMake sure to see that the install area is clean and dry. With a helper, maneuver the tank to the installation area and set it in place. Line up your connections and using the torpedo level, make sure the unit is straight. Step 4 - PRV & WaterOnce the tank is in place, install the pressure relief valve (PRV) and connect the lines using joint compound on the galvanized connections and Teflon tape on the copper ones. Now you are able to go ahead and fill the tank. Step 5 - Set Thermostat & Connect the ElectricConnect all of your electric wiring and make sure it is all tightly secured. The heater thermostat should be set between 110 and 130 degrees. Turn the electricity on. Wait thirty minutes to an hour and test the water temperature by checking the faucet outflow. Tips to Remember: 1. You may have to used flexible copper supply lines in the case that you cannot line up your outlet and inlet openings on the new unit with your current plumbing.2. Always keep at least one hot water spigot open when filling the tank to avoid trapping air in the water lines. With any DIY job, its important to keep your head about you. Dont be afraid to consult a professional with any questions you may have. You just may end up saving yourself from a bigger problem later on.
Water,Heater,Installation,Step