Cisco,CCNA,640-802,CCENT,Certi computer Cisco CCNA 640-802 / CCENT Certification Exam Training: Fra
Gone are those times when the companies and the organisations didn't need a hi-tech system to handle them. Owing to the considerable increase in the business sector and thus, an enormous increase in the complexity of the organisational struc ----------------------------------------------------------Permission is granted for the below article to forward,reprint, distribute, use for ezine, newsletter, website,offer as free bonus or part of a product for sale as longas no changes a
For success on your CCNA 640-802 and CCENT exams, you need to understand how and why Frame Relay LMI messages operate. You need to know this for real-world networking as well, since Frame Relay is prevalent in today's networks - and without LMI, you have no Frame Relay! The Local Management Interface (LMI) messages are sent between the DCE, typically the service provider, and the DTE, the Cisco router. LMI Status messages serve as keepalives for the frame connection. If keepalives are not continually received by both the DCE and DTE, the frame connection will drop. The LMI also indicates the PVC status to the router, reflected as either active or inactive.The LMI types must match on the DTE and DCE for the PVC to be established. There are three types of LMI: Cisco (the default)ansiq933a The LMI type can be changed with the frame lmi-type command. Before doing anything with the frame relay commands, though, we have to enable frame relay on the interface with the encapsulation frame-relay command. Remember, the default encapsulation type on a Cisco Serial interface is HDLC.R1(config)#interface serial0R1(config-if)#encapsulation ? atm-dxi ATM-DXI encapsulation frame-relay Frame Relay networks hdlc Serial HDLC synchronous lapb LAPB (X.25 Level 2) ppp Point-to-Point protocol smds Switched Megabit Data Service (SMDS) x25 X.25R1(config-if)#encapsulation frame-relayR1(config-if)#frame-relay lmi-type ? cisco ansi q933aWe can hardcode the LMI type as shown in that example, and there's another way to get the LMI to match with the remote DCE. LMI Autosense has the router send out an LMI Status message for all three LMI types.The router then waits for a response for one of those LMI types from the DCE. When the router sees the response to its LMI Autosense messages, the router will then send only the same LMI type it received from the DCE. On rare occasions - such as your CCNA exam, perhaps :) - the Frame LMI may not match. We'll take a look at such a scenario in the next installment of my exclusive Cisco CCENT / CCNA 640-802 certification exam tutorial series!
Cisco,CCNA,640-802,CCENT,Certi