DIY,Install,Car,Steering,Wheel car DIY: Install a Car Steering Wheel
General Lee: For such a TSP platform, indeed, is the test of the ability to integrate the same time, just She always has been mentioned in the business platform is a completely independent intellectual property platform and our platform is t In the shape of the design, the Core wing broke through the traditional appearance of the other models, the Core-wing sense of movement and high-level sense of the high degree of balance, which must be improved, both in the interior styling
Removing the Old Wheel Orientate your vehicle so the wheels are pointing straight ahead.Before working on the car you should disconnect the battery. Do this in order to prevent the horn from sounding while you work on the steering wheel. Alternatively, you can remove the horn fuse from the fuse box.Next, remove the horn mechanism. Press down on the center of your steering wheel to depress the horn cap. Then twist the cap or ring and remove the horn emblem cap. To do this, you will need to pull it off or pry it loose. Your horn cap may be attached by the use of screws. If this is the case you will need to unscrew them prior to removing the cap.Disconnect the horn wire or the connecting mechanism. When disconnecting the horn, you may be forced to clip the wire below the plastic sleeve. Save this sleeve for later.Detach the steering wheel by removing the nut-shaft.Place a mark on the shaft. This should be placed at the 12 o?clock position. This is done so you can make sure the steering column is properly lined up when you replace the nut-shaft.Pull off the hub of the previous steering wheel, using a pliers or a puller. Next you can remove the old steering wheel. Installing the New WheelPlace the metal sleeve over the steering column.Place the hub over the shaft, lining up the shaft with the previously applied mark. You may be required to rotate the plastic horn tube in order to properly align the hub in the necessary position.Take the plastic sleeve and spring, and re-insert them into the horn housing.Insert the new wire lead into the plastic sleeve. The larger end should come into contact with the horn housing. Next, insert this assembly into the housing and lock it into the proper position.Place the new wheel on the column, feeding the new wire through the center holes. Properly align the new wheel. Fasten the hub to the steering column once the wheel is in the correct position.Re-attach the shaft nut. Once finished, re-install the shaft nut retaining clip next. Tighten the nut and shoulder bolts.Re-connect the lead wire to the connector. Position the spring in its proper spot on the center nut. Re-align the horn cap and push it back into place. Turn the cap until it properly tightened.Re-connect the battery, or re-install the horn fuse.
DIY,Install,Car,Steering,Wheel