The,overall,cabin,construction car The overall cabin construction of a radio control car
In the shape of the design, the Core wing broke through the traditional appearance of the other models, the Core-wing sense of movement and high-level sense of the high degree of balance, which must be improved, both in the interior styling General Lee: For such a TSP platform, indeed, is the test of the ability to integrate the same time, just She always has been mentioned in the business platform is a completely independent intellectual property platform and our platform is t
When constructing a radio control car cabin, you need to determine some aspects. The furnace consists of 2 parts a fixed part as a table where you place the model and where we will perform the vacuum hot plastic to adjust the model. Like the plastic sheets are available in size 74x100 CM fixed part of the oven is 74x50 CM, in this way with each sheet can make 2 cabins. This part has at its lower part a metric plumbing pipe with an elbow 12 which passes through the center and is where we will perform aspiration. Angles are also placed at the corners to guide the oven.The radio control car moving part is a case of DM with dimensions of 74x50x40 CM painted inside with paint resistant to heat. Inside you may place a resistance furnace with a minimum of 3000 W. In this furnace that is missing a lid fastened with the plastic sheet. The void we're going to get metric pipe connecting the fixed portion 12 at the entrance of air from a compressor with a piece of hose, depending on the compressor that we have to do a piece to match the compressor air inlet to the hose.Once we have fixed the furnace connected by hose to the radio control car compressor, we take the model, we fit with a 1 cm blocks is free to the vacuum (we can see in the first and second photograph of the beginning of this article), subjects it to the table with double sided tape and give it furniture wax will not stick to plastic. Moreover we have the oven with the plastic piece bolted on top and the resistance unplugged for at least 20 minutes for plastic sheets 0.5 mm thick.After these 20 minutes the plastic sheet and has to be soft so we can go around the oven and sit against the fixed part is the model in the center so we get the sheet to fit it, a Once the fixed part of the furnace and the moving part are linked with resistance adjustment can be finished with briefcase closures. It is now time to start up the radio control car compressor so that the finished plastic sheet conform to the model and in this time when we remove the resistance to plastic to cool and once we disconnect the cold and the compressor and remove it all. Article Tags: Radio Control, Fixed Part, Plastic Sheet
The,overall,cabin,construction