How,install,car,backup,camera, car How to install a car backup camera on your car
In the shape of the design, the Core wing broke through the traditional appearance of the other models, the Core-wing sense of movement and high-level sense of the high degree of balance, which must be improved, both in the interior styling General Lee: For such a TSP platform, indeed, is the test of the ability to integrate the same time, just She always has been mentioned in the business platform is a completely independent intellectual property platform and our platform is t
As we know insert the power supply for the carcamera display monitor into the cigarette lighter should plug on the car'sdashboard. Auto Aftermarket car cameras mostly are wireless, so there is noneed many connection to make between the view monitor which places on the dashand the car camera which installs at the rear license plate. But, the cameraneeds power, as does the monitor. The car's reversing lights supplies aconveniently placed power source for the camera that switches the camera ononly when needed. The view monitor display on the dashboard uses power from thecigarette lighter plug.You'll Need Car upholstery removal tool, Drilland bit, Wire strippers, Grommet and Electrical tape.Process1Remove the plastic or carpet panel on theinside of the trunk behind the license plate and below the trunk lid. If yourcar is an SUV or something similar, expose the innards inside the tailgate.Process 2Install the camera. Remove the two licenseplate bolts and insert them through the camera bolt holes and back onto thecar. Use the license plate light hole to put the wiring through to the trunk.Process 3Run the red and white cable from the car camerayou have installed on the license plate frame to a reversing light housinginside the car. The license plate light can supply a convenient hole, or simplydrill a new hole and weatherize it with a grommet.Process 4Trim and strip 1/4 inch of plasticsheathing off the end of the wire at the reversing light housing. Identify thecar wires that offer power to the reversing lights. Identify them by tracingthe wiring back from the reversing light bulb connector. Strip 1/4- inch ofplastic sheathing and off the wire. This should be at a convenient, easy toreach location--the middle is fine. Wrap the car camera wires around thereversing light wires, match red wire to red and black wire to black. Seal withelectrical tape.Process 5Attach the display monitor to a convenientposition on the dashboard. Use the contained hook and loop tape. Insert thepower supply from the view monitor into the cigarette lighter plug on the car'sdashboard. Test and then replace the plastic or carpet panel.Fortunately, we are the professional of carcamera; you can contact us for your questions, or get some product from ourwebsite www.carcameras.net
How,install,car,backup,camera,