How,Your,Own,Oil,Change,And,Sa car How To Do Your Own Oil Change And Save A Few Bucks
General Lee: For such a TSP platform, indeed, is the test of the ability to integrate the same time, just She always has been mentioned in the business platform is a completely independent intellectual property platform and our platform is t In the shape of the design, the Core wing broke through the traditional appearance of the other models, the Core-wing sense of movement and high-level sense of the high degree of balance, which must be improved, both in the interior styling
You've got to get an oil change every 5,000 or so miles. This is a bit of car maintenance that is absolutely essential for your vehicle. Although you can get it done cheaply at most car repair shops, you can get it done even more cheaply by doing it yourself at home. Here's a step by step guide to performing your own oil change.Step One - Get ReadyFirst of all, make sure your engine isn't hot when you do the oil change. Let it cool down for a little while. If it's piping hot you might end up burning yourself and that's just no good.Now, pick a good place to do it. You need a level spot where you can jack your car up. You'll also want it to be a place where a little spilled oil isn't going to ruin anything. You might want to put a piece of cardboard or plywood underneath just to be safe.Step Two - Drain The Old OilGet your car up on jackstands and then get under it. Look for the drain plug. It should be fairly low to the ground. It will probably be labeled and, if not, you can always check your car manual to see where it's supposed to be.Using a wrench, turn that large nut until it starts to loosen and turn. If it doesn't at first, try harder. It may take a little muscle to get it to move. Keep turning it but don't unscrew it completely unless you want to get covered in motor oil!Before you let it gush out, grab your oil pan. With the pan in place, unscrew the drain plug carefully until a little stream starts coming out. Once it's positioned just right, let it rip and move the pan if you need to in order to catch the stream.Step Three - Change The FilterThis part can be a little tricky. You've got to first remove the filter, which can be hard. Every car is slightly different, so keep working with it until it starts to come loose. Before putting the new filter in, rub a little of the new oil onto it. This will help it adjust to the change in pressure the next time your car starts.Step Four - Screw It All Back TogetherWith the old stuff drained out and the new filter in place, the last thing you need to do is replace the nut. Screw it back in being careful to keep the threads on track. You don't have to screw it on really tight; just enough so that it doesn't give any more. You don't want to strip it because this can cause bigger problems.Now, add your new oil into the regular spot under the hood and you've successfully completed your own oil change! Once everything's closed up and finished, start your car. Keep it in neutral with the parking brake on, and step outside for a look underneath to check for drips.After the first time, it will get much easier, and you'll never have to spend another penny at the garage getting this easy task done!
How,Your,Own,Oil,Change,And,Sa