Thermal,Effects,Welding,ERW,Pi business, insurance Thermal Effects of Welding ERW Pipe
As we all know to live in this world we have to perform some activity by which we can earn money. There are many activities by which we can earn money and meet the standards to live in this society. And from one of them is franchise. Franc Small offices have unique needs, and thatincludes document shredding. Designed with the smaller business inmind, the Dahle 20314 is a cross-cut shredder that offers Level 3security and brings you into compliance with federal regulations. The
ERW pipe welding in the pipeline industry, shorten the construction time and reduce the related costs of voice getting higher and higher. One way to reduce costs is to shorten the welding time or by using higher welding speeds and / or fewer beads. However, the former method may increase the welding defect rate, and the latter method may result in an increase in heat input. Unfortunately, it is often observed that high heat input soldering can cause performance degradation in the HAZ. Therefore, we want to optimize the steel's ability to withstand a wide range of welding conditions. The main cause of deterioration is the large original austenite grain size and the coarse discrete particles produced by some chemical reactions, such as the presence of carbonitrides of Ti and Nb in welded steel pipe.As the first step in improving the tolerance performance of X70 pipeline steel to different conditions, we produced a series of steel tubes of different chemical compositions and attempted to determine their tolerance performance for control of the weld thermal cycle for various alloy chemistries. The 7-lot API 5L X70 Ti-Nb microalloyed steel was selected to have different Ti-Nb contents and a Ti / Nb ratio range was determined. We also note that the carbon content in each sample is also different. All of these materials were automatically welded using a typical in-situ girth welding process, then the microstructures of the weld and heat-affected specimens were tested and the toughness of these areas was tested by mechanical testing. In addition, the heat-affected zone was also simulated using a gleeble thermomechanical simulator. The purpose is to give the same heating to all the specimens and to create a larger test and observation area, which is usually small for real welds. In order to simulate the thermal cycle of a coarse heat-affected zone during GMAW welding, the welded steel pipe was heated at 250 °C / s and held at a peak temperature of 1425 ° C for one second to stabilize the temperature and avoid The stream is then cooled and the cooling time from 800-500 °C is 0 sec. Use a 12mm space. The temperature range of 800-500 °C (t8-5) is generally considered to be the governing factor determining the microstructure and properties of the heat affected zone, as the transformation typically occurs at this temperature. Cooling at 800-500 °C for 10 seconds represents the measured cooling rate in the non-reheatable heat-affected zone of the fusion line near the multi-channel GMAW weld.
Thermal,Effects,Welding,ERW,Pi